How do you properly prepare for your temporary fence installation?
Having installed thousands of temporary construction fences, American Fence Company’s crews have sat idle at many job sites while the contractor frantically tried to figure out where to put his construction fence. We have also gone back to just as many job sites and relocated the temporary fence due to their lack of preparation. This is not how you want to start any new project. Before our crews to get to your site, please consider some easy preparation. You should start with:
- Stake the location of your fence
- Locate your property line. We have watched hundreds of job site superintendents scratch their heads as they tried to figure out where the property line is located.
- Be aware of any setbacks or easements. Any new construction project is going to involve relocating or connecting to utilities. Setting your temporary construction fence in the way of utilities is a surefire way to guarantee having to relocate it.
- Be aware of blocking visibility at intersections and city codes prohibiting obstructions at intersections. No one wants to watch a pile-up from their job site trailer. Blocking visibility of oncoming traffic at an intersection can be a very dangerous act.
- Consider contractor access to the site for equipment and materials. Most materials delivered to the site will be via a flatbed tractor trailer. These trucks are almost 85 feet long and require half that amount for a turning radius. Allow these deliveries room to access the site.
- Consider storage of onsite materials. Contractors will deliver truckloads of sand, blocks, brick, insulation, red iron, roofing, etc. You should consider the storage of all this material beyond the limits of construction. No one wants to pay to move materials around the site.
- Consider contractor parking. If you want contractors to show up to work, you have to allow them a place to park. When you force your work force to park outside the site, you often block deliveries, etc. You will spend more time as a traffic cop then you may want to.
- Consider site conditions that may not allow the fence to be kept tight to the ground. What good is a construction temporary site fence if you allow areas for others to crawl under the fence?
- Consider placing the fence next to any structures that would allow ease in climbing the fence. Installing the fence tight against transformers, signage, stored materials, etc. is inviting others to climb in or shuffle materials out.
- Stake the location of your gates
- Consider codes and traffic laws regarding exit and entry relative to intersections and busy streets. City officials study entry and exit to any new project. This also applies to construction access. Installing a temporary construction gate in close proximity to an intersection is a recipe for an accident.
- Do you need jurisdictional approval for these access points? Temporary site access approval may be required during the permitting process. Don’t forget to ask.
- Consider equipment and material deliveries with large tractor trailers. Large tractors and trailers cannot turn into construction sites where the gate is set tight to the street or right next to an intersection.
- Consider worker arrivals and departures. Hopefully, your subcontractors show up to work. When they do, don’t create a traffic jam by using the same gate for deliveries.
- Clear the site. Be sure the site is clear of any vegetation, equipment, materials, etc. A temporary construction fence is only useful if you make it visible and in-line of site of the general public. Install your fence in shoulder height weeds and you are allowing thieves the time and cover to access your fence.
American Fence Company is the Midwest’s largest fence installer and has locations in Nebraska, Iowa, Minnesota, Kansas and South Dakota. If you would like a free quote for your temporary fence job, please visit us at http://fencerentalcompany.com/ today.